Cleaning the Food Processor can be very simple. But if it is not washed after use, it will take a lot of effort. If you don't have time to run out and wash immediately, at least pour the detergent described below into soaking, and then wash again when you have time.

Cleaning the juice Blender mixer machine steps:

1, before using, make sure that all parts of the food blender processor are installed and connected correctly, especially the transparent pot and the base should be tightened.

2. Add about half of the water.

3. Add a few drops of detergent. If you have a lemon on hand, cut it in half. During the mixing process, lemon zest and lemon juice can just help wipe the stains on the wall of the pot.

4. Power on the blender machine, close the lid, and use at low speed for 30 seconds.

5. Check to see if all the stains have been washed away. If not, repeat the above steps.

6. Pour out the liquid inside.

7. Rinse the jar under the tap.

8. Place the spout down on the dish rack and air dry.

Percent HOW tips:

1, it is a good habit to wash and wipe after use, and it is also a relatively labor-saving method.

2, make sure all accessories are dry before storing when not in use.

3. If the electric blender machine is really too dirty, you can mix baking soda, vinegar and detergent for a while, then let it stand and soak overnight, and then stir, so that most of the stains will be washed off. For stubborn stains, You can try a toothbrush and brush.